These under shrouds were developed to protect your critical engine parts under the car and also because the cheesy plastic OEM shield deteriorates over time and usually ends up on the highway behind you somewhere.

The under shrouds will fit all 2003-2008 350Z's with stock front fascias and should fit any fascia that the OEM under shroud still bolts to. These have only been test fitted on stock bumpers.

This piece will help give the lower front fascia much more rigidity also, As you probably know, running without the shield in place at high speeds can do serious damage to the front fascia as it will droop down and can rip apart.

The BEST feature of all thou is that you can actually change your oil AND filter without removing the entire shroud. I have integrated a oil change access door into the shroud so all you have to do is remove 2 bolts and you have ample room to get to the oil filter and drain plug even with the GTSpec V1 front tie bar in place.

Weight on the entire piece is 4.5lbs, The plastic OEM shield for reference weighs in at a bit over 3lbs.
Very lightweight and much more protection!

Mounted, this was one of the last prototypes. The production pieces have 2 bolts on the oil filter door.

As you can see in this picture I wanted to keep as much ground clearance as possible, this will be very close to the level of the front fascia all the way back to the oil pan area. There is a little over 1" of clearance between the oil pan and under shroud so those of you with the 1" oil pan spacers should not have a problem clearing.

This is the finished piece. I have made these in 2 pieces due to the fact that you may crush the front piece on a curb/parking block (it happens to the best of us) it can be replaced without having to buy the entire shield again. The front piece will be available separately in the future.

Assembled before installation to car

Powder Coated, Matte Black

These are available in the raw aluminum shown and also in a Matte Black Powdercoat finish.

Bare Aluminum $249.00
Aluminum with Matte Black Powdercoat $289.00
Hardware Kit $15.00
Replaces all hardware associated with mounting the shield, all new bolts and U-nuts.
Shipping is $20.00 anywhere in the lower 48.
E-mail for different shipping destinations and I will get you a quote.
Spddracer@aol.com

Fitment
2003-2008 350Z ... I have verfied fitment with the JWT oil pan spacer (yes it clears)
2003-2006 G35 Coupe, Please confirm you are ordering for a G35 as the front panel is slightly different.
This has only been test fit with stock front fascias. May require modifications for aftermarket Fascias.

Aluminum

PC Matte Black

Hardware Kit

Modified by Spddracer at 9:33 PM 10/16/2009